Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have a 4507 and I have the ports configured for full duplex. The routers connected are also set for full but for some reason, the switch keeps negotiating to half-duplex. Maybe this is a common issue with an easy fix but I can't seem to figure it...
I am using Cisco AnyConnect client v2.5 on a Windows 7 64 bit OS. If I restart the laptop, I am able to connect with no problem. If I disconnect for any reason and try to reconnect, I am given the error "VPN User Interface has stopped working." At...
Greetings,We have two ASA's that will be used for VPN access. Initially only IPSec connections but eventually, we'll be using the SSL Web connections as well. I was curious which failover configuration would be more appropriate. Active/Active or the ...
Greetings,I am attempting to set up dot1x using the certificates on our CAC cards to authenticate. I have been able to set this up where when the smart card is inserted into the reader and after entering your PIN, the system will authenticate and le...
Greetings,I am attempting to set up a 2800 series router for dial up access. I would be using Windows XP to set up a connection, via the modem, to the router. I am able to reach the router and begin handshaking but when it goes to authenticate my u...
Thanks for your help guys...I did have the speed set to auto. Once I set the speed, the ports reset to full. I don't think I've had to do that before but I honestly can't remember. Anyway...thanks ain for your help.
Yeah I was looking at Active/Standby but my boss feels that if we are using it for VPN (IPSec and SSL) he thought one unit may be doing too much and would rather have some type of load balancing in place. So it seems the VPN cluster may be the best ...
So if I am understand what you are saying correctly, I cannot use Active/Active while using remote VPN. I'd have to use the VPN Load Balancing to utilize fault tolerance. Is this correct?
I have MS-CHAP-v2 enabled under global authentication along with v1. Its still behaving the same way. I am authenticating against Active Directory so it does allow MS-CHAP-v2 according to the chart.
Thank you very much, this chart has helped. I am able to get it to authenticate using PAP. I had one more question that maybe you can help with. I was going to try to get it to authenticate using ms chap v2. For some reason, that is not working w...
