Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi guys,I saw that NX-OS does not support a request via Netconf, without a filter.<rpc-reply xmlns="urn:ietf:params:xml:ns:netconf:base:1.0" message-id="1">
<rpc-error>
<error-type>protocol</error-type>
<error-tag>operation-not-supporte...
Hi everyone,I found some designs in our network which I haven't seen in any configuration guides. I hope that someone can have a look at our network and point out some design errors or missconfigurations. Attached you'll find a picture with the topol...
Hi everyone,
I have two ASA5512-X on which I like to configure HA. When I activate Failover on the standby unit I get the following error message:
Detected an Active mateMate NOT PRESENT card in slot 2 is different from mine CXSC5512
I guess this i...
HelloFor a customer I have configured a workgroup bridge. To improve the roaming the workgroup bridge only scan three different channels (100, 108, 116). When the other access point (not the workgroup bridge) use DFS they can change the channel.Can I...
Hi Marcel,Thank you for your answer. This is from the documentation:Beginning with NX-OS 9.3(1), NETCONF get and get-config requests from the NETCONF client to the switch must contain an explicit namespace and filter. This requirement affects request...
Hi,
the factory-reset didn't work. But I noticed that on the standby firewall there was a sw-module activated. I didn't check that because the show command hasn't shown it.
Now I am running a failover cluster with the software version 9.6.3.
Thank yo...
I downgraded both ASA but unfortunately I get the same error.
I'll try now to reset the active Firewall and reconfigure it. I'll let you know if this helps.
At beginning I had the OS version 9.3 and upgraded to 9.7. Then the standby ASA reloaded and booted without a config.
Yesterday I made an upgrade to 9.8.
Thanks,Remo
Thank you both for your reply,
I tried to uninstall the module with:
sw-module module cxsc uninstallThen I get the following error: Unable to uninstall module cxsc, it does not have a software image installed
The problem occured when I upgraded the A...
