Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,Can anyone help me to configure/troubleshoot Cisco MDS 9148 with Cisco USC ? M stuck in port channel..i have configured but interfaces are not coming UP.It is showing init state.My Topology is like,Nexus 5000-->USC FI (single FI) -->Cisco MDS 9...
Hi all,I need to configure ssh on my 3560 switch integrating with Microsoft IAS and when user try to access switch they need to use their domain credential for that, But i am getting following error message,"011192: Feb 16 20:30:01: %SSH-5-SSH_SESSIO...
Hi,I am configuring aaa-server on ASA-5505(Radius) and i am Using microsoft IAS for authentication for SSH connections on ASA, so during " test aaa-server authentication " i getting this message ERROR: Authentication Server not responding: AAA decode...
Hi Manuel,Yes MDS and UCS interfaces are UP.when is run F_A(nxos)# show interface ethernet 1/1 | in Hardware this command nothing comes.TMC-UCSFI-A-A(nxos)# sh interface ethernet 1/1 mac-address -------------------------------------------------------...
Hello Padramas, Following are the commands configured on MDS:- interface fc1/15 switchport rate-mode dedicated port-license acquire channel-group 2 force no shutdowninterface fc1/16 switchport rate-mode dedicated port-license acquire channel-g...
HI minkumar,No, its only one. I have done same configuration on 2960, every thing is working fine.i dont understand what is the issue with 3560.Regards,Praveen
