Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Using Yagi's, low loss cable, antenna outside, AP inside.When operating autonomous 1250 series in root/non-root bridge mode, can I use 802.11N radios? Is it supported?Or would it be better to use 1242's? This is for a customer, no time for testing, n...
My customer will have:ISP 1 for data (30MB) vlan 1 (carrier provided a Cisco 800 and public IP) up and runningISP 2 for Voice (SIP) vlan 100.I am looking for the data configuration on FA0/1/0 to send my data traffic to ISP 1 cisco 800.The WAN port wi...
How safe is split tunneling a remote access vpn client 5.0.04.0300. The tunnel is termined on a ASA 5520 7.2. Management wants the webfiltered for remote users, we have a websense remote server in the dmz and a websense client on the laptops. I alway...
@leolaohoo -I was just asking for a definitive answer, weather its affirmative or negative, is there a benefit to using the 1252 over the 1242 giving the cost of each, since as you said the 802.11N can not be used to bridge, than I would say a 1242 ...
Steve - good informaton, I will use it... Nonetheless, I'm looking for the CLI administrators guide for the administrator, not the end users... I did say for the mac users, sorry about that... Not the end users, just the administrator...I want to l...
BillA great guy named Joe suggested setting up a vlan x with IP address and untrust an FA port in security zone for that port, assign the vlan to the untrusted port, route the data traffic out to that vlan x. Any comments?
Marco or (anybody)Do you have an example of the CLI commands on a UC-540 to get the disered results?Data VLAN to the ISP provided cisco 800 for 30/30 mbVoice vlan to the WAN port SIP trunk 1.5mb 8 concurrent calls.
