Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have a 2600...With T1 to internet..also have DSL but it goes into its own DSL Router...so I have an ethernet connection to the second Ethernet connection on the 2600.... There is no NAT running on the router...I have NAT being done by a PIX....what...
Not looking for a Complex solution........I have a T1 with bellsouth and a DSL line for bellsouth...I have the T1 set up on Serial 0/1 with one static route.....I have the DSL connected to Ethernet 0/1 with a crossover cable going to the DSL Modem.....
I have a pix 6.3 when I use the Cisco VPN Client software to connect to another companies VPN.....it connects and gets an ip on the inside of there network but it will not pass packets....it works fine out side of the PIX any Ideas?
Firewall has fixed IP on untrusted and PPTP configured and running with local username and password list and a small pool of Ip's.....worked great untill I brought up an IPSEC VPN with the following commandsisakmp enable outsideisakmp policy 9 authen...
You Wrote A book.....that is out of print...but I can get signed copy from you....we have spoken in this forum before..about this very topic...I want your help ..I think you have a chapter on this.....maby chapter 8?I want your help ....I need your h...
any thing the Public See's is off site in a colo ..... your response is a little confusing...."This assumes that all your inside users can be assigned IP addresses from your T1 public block "This is incorrect..I have a PIX firewall that does NAT........
T1 is Frame Relay , and DSL does not use same public IP's I have a small block of Ip's for both the T1 and the DSL.....and the DSL is not doing NAT The IP I have on both of interfaces are Valid Routable IP's..Please Advise...Thanks James
