Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Ok,Turns out that this feature is not supported in the BIOS for the models before B440. That is why you're not seeing it in the GUI.If you try to commit the config in the BIOS defaults CLI settings, it will error out as well.That would be why when yo...
Hi Robert, StevenI found the same issue here. I've filed a bug (CSCtj48192) to have it investigated. Seems like you can do it in the CLI, so it's only missing in the GUI.You can set it in the CLI using the following:apac-dcn-ucs-01-B# scope system
ap...
Hi,mac pinning is a new feature of the latest software release and therefore wasn't available previously. Before that, VPC HM was recommended in the prior release.The benefit of using mac-pinning is you don't create separate subgroups for each uplink...
Hello,The message relates to memory management of the switch, and is seen on multiple IOS-based platforms, usually during bootup.There is a current bug open on this issue, CSCsj74064. If you upgrade to 12.2(44)SE or later, the issue will not occur an...
This message typically means a hardware failure.If you plug a console into the switch and watch it boot, you should see a particular message indicating POST failure on a specific line, something like this:POST: PortASIC CAM Subsystem Tests : BeginTCA...
