Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Ok,Turns out that this feature is not supported in the BIOS for the models before B440. That is why you're not seeing it in the GUI.If you try to commit the config in the BIOS defaults CLI settings, it will error out as well.That would be why when yo...
Hi Robert, StevenI found the same issue here. I've filed a bug (CSCtj48192) to have it investigated. Seems like you can do it in the CLI, so it's only missing in the GUI.You can set it in the CLI using the following:apac-dcn-ucs-01-B# scope system
ap...
Hi,mac pinning is a new feature of the latest software release and therefore wasn't available previously. Before that, VPC HM was recommended in the prior release.The benefit of using mac-pinning is you don't create separate subgroups for each uplink...
Hi Wadge,When modules are not seen on the show mod command, this typically means that the control/packet vlans aren't working end-to-end.Can you please ensure that the switch/switches between the VSM and the VSM are carrying the control and packet vl...
Hi,As UCS does not support Private VLANs, you can't configure your uplinks on the N1000v as regular trunk ports.Therefore, you will need to configure them as promiscuous trunk ports. This can be done as per the config guide: http://www.cisco.com/en/U...
