Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi Everyone. I recently did an IOS upgrade from 12.2(18)SXF4 to 12.2(33)SRB1 on a 7609 MPLS PE Router. No config changes were done. However, after the upgrade, some OSPF and static routes for some VRFs went missing. Has anyone ever encountered suc...
Hi. I have two Cat6506 (redundant collapsed-core config) configured w/ RPVST+ and connected to this are a series of Cat2950s configured with PVST. My question is, is this a good practice configuration of STP? (running both RPVST+ and PVST on the sam...
Hi. Has anyone tried using Cat6500 MSFC2 (MEM-MSFC2-256MB) DRAM as a substitute for SUP2 (MEM-SUP2-256MB) DRAM? I've already done this with our Cat6500 and was able to boot it up, but i'm worried of any hardware instabilities (if there is any)that ma...
Hi. Has anyone ever done a fast software upgrade on a Cat6509 configured with SSO redundancy? I only found a procedure using RPR+ mode:(http://www.cisco.com/en/US/products/hw/switches/ps708/products_configuration_guide_chapter09186a0080160a91.html). ...
thanks for the inputs. yup, the Cat2950 supports rpvst+. so you're saying that although i'm running rpvst+ on my root bridge (Cat6509s), still the convergence would take the 50 sec pvst+ standard (since the STP timers are dependent on the root bridge...
Hi guys. I though so too that its possible, and i need the quick affirmation. thanks!Here's the setup:- 4500s are running OSPF (actually part of a Core network of 3 nodes, so that's 3xCat4500, with 1 unit per node);- the 3 Cat4500s are in full mesh;-...
