Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
For some reason some AIR-AP1131AG-E-K9 access points are not joining the wlc.I'm using the latest recovery image to convert from autonomous to lightweight (c1130-rcvk9w8-mx.124-25e.JAO5)- The time on access point and wlc is the same- We're using mult...
I'm working on a new wlc installation for a customer. I've create a wlan with a customized web-auth. page that uses an external freeradius sms gw. I've setup FlexConnect, so the wlan is locally switched but the WLC is the authenticator.The problem is...
Hi,See attached imaget to see how things are configured today. We also want to have local switching on Guest wlan in the remote location but have so far been unsuccessful. My knowledge regarding anchor controllers is limited, so I was wondering what ...
Problem: When connecting to the CWA ssid, the client gets redirected to: https://lab-ise01.lab.local:8443/guestportal/gateway?sessionId=3c02a8c00000000878430a51&action=cwabut the link times out.I'm currently following this guide: https://supportforum...
I've set up a 2504 wlc and 3x 3602i access points.The problem is that I'm only able to connect to the first SSID created (SSID1), not the second (SSID2) or third (SSID3)If I delete all SSIDs and create SSID2 first, then it will work, but not SSID1 or...
I was not using the Upgrade Tool earlier but I converted the 1130 access point back and then converted them to lightweight again using Upgrade Tool. The tool generated the SSC certificate and the access points finally joined the controller.Thanks to ...
I followed the instructions on that site but I can't see the SSC Key Hash string in the log when I issue the command 'debug pm pki enable' See attached log.I have two 1131 access point continuously trying to connect to the wlc. Any thoughts on why it...
FYIFore some reason we were using Passthrough and not Authentication on the SSID. After changing to Authentication and opening port 1812 all the way through to the radius server, everything worked.
I thought I might be hitting the bug mentioned in the following thread. https://supportforums.cisco.com/thread/2191587Oddly enough, updating the vWLC to v7.3.112.0 did not resolve the problem. (ISE is v1.1.2)I still cannot reach anything from the the...
