12-03-2013 03:22 AM - edited 07-04-2021 01:21 AM
Hi,
See attached imaget to see how things are configured today. We also want to have local switching on Guest wlan in the remote location but have so far been unsuccessful. My knowledge regarding anchor controllers is limited, so I was wondering what configuring is needed to have local switching on guest wlan in the remote location. Appreciate any suggestions!
12-03-2013 04:53 AM
It sounds like you are doing flex but you didn't mention that. Assuming you are, you want to make sure the guest WLAN is anchored from the foreign controller (central) in your example to the anchor controller. And then anchor the DMZ guest WLAN to itself.
Here is a config example document
http://www.cisco.com/en/US/tech/tk722/tk809/technologies_configuration_example09186a00808ed026.shtml
Sent from Cisco Technical Support iPad App
12-21-2013 06:18 AM
#On guest wlan you can either do local switching with one wlc or anchoring using DMZ controller.
#webauth is supported on local switching.
#With the above setup, convert the remote APs to flexconnect mode and enable local switching on wlan. keep the same webauth config on wlc.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide