Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have 5 1602I-A-K9 series AP's that I need to add 40 MAC addresses to. What is the best way to add the MAC addressees? I know how to do it one at a time, just looking for a more efficient way to do this.
System Software Filename:ap1g2-k9w7-tar.152-...
I have a 2504 WLC that I have 1042 and 1602 AP's connected to already and working great. I purchased some AIR-CAP2702i-A-K9 AP's. When i connect the new 2702 AP to the network, it is not connecting to the controller. It just flashes Red and Green.
%L...
How do I add another management interface to a 2504 controller? I have port 1 setup when I first installed the WLC. But I want port 2, with a different ip address, to be able to access the WLC too.port 1 = 10.0.0.1/24 which works ok.port 2 - 10.17.1....
I have 5 new AIR-SAP1602i-A-K9 standalone AP's that are going to replace the 1130AG AP's currently in use. I need to upload over 200 MAC addresses into the new AP's. It there a better way than 1 at a time? I have them all in excel spreadsheet. A cont...
I have a 2504 controller with 1142 AP's. Running a MS NPS. All other devices (laptops, ipads) connect. The MS Surface tablet does not take my credentials. Has anyone been able to resolve this?TIA,Eric
Will it add the password part automatically?
it looks like this now:
username 00226966522d password 7 075F711E1C5F40534147595E00
username 00226966522d autocommand exit
Thank you for the answers.
The firmware goes from 7.4.140 to 8.0.133. There is no 7.6.120. Will my older AP's work with the 8.0.133 without issues?
TIA