cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
459
Views
5
Helpful
1
Replies

Adding another mgt interface 2504

Eric Kemsley
Level 1
Level 1

How do I add another management interface to a 2504 controller? I have port 1 setup when I first installed the WLC. But I want port 2, with a different ip address, to be able to access the WLC too.

port 1 = 10.0.0.1/24 which works ok.

port 2 - 10.17.1.25/16 is the other port i want.

1 Accepted Solution

Accepted Solutions

Scott Fella
Hall of Fame
Hall of Fame

If you created a dynamic interface and assigned that to port 2, what you need to do to access the WLC management is to allow management via wireless using the dynamic interface.  This is the command you need to enter:

config network mgmt-via-dynamic-interface enable

-Scott

-Scott
*** Please rate helpful posts ***

View solution in original post

1 Reply 1

Scott Fella
Hall of Fame
Hall of Fame

If you created a dynamic interface and assigned that to port 2, what you need to do to access the WLC management is to allow management via wireless using the dynamic interface.  This is the command you need to enter:

config network mgmt-via-dynamic-interface enable

-Scott

-Scott
*** Please rate helpful posts ***
Review Cisco Networking for a $25 gift card