Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Need a little direction here.Our office currently connects to two remote offices via IPSEC LAN-to-LAN tunnels.Tunnel 1 (Office 1 to Datacenter): 10.2.0.0/16 (remote office 1) <-> 10.1.128.0/19 (datacenter)Tunnel 2 (Office 2 to Datacenter): 10.1.60.0/...
ASA 5510Need to NAT single public IP to multiple internal IPs.Outside:1.1.1.1/25 -> DMZ:192.168.1.10/25while...Outside:1.1.1.1/443 -> Inside:192.168.2.10/443andOutside:1.1.1.1/1352 -> Inside:192.168.2.10/1352Initially tried (via ASDM) static P/NAT fr...
Good day.I wish to seek some advice as we evaluate a re-design of our WAN structure.Currently we have multiple offices around the world. Our current design is a full-mesh IPSec network over the commodity internet.We now have 3 offices designated as ...
See attached picture...I'd like to leverage a peer router to direct some VPN traffic. Can anyone tell me if this approach is possible or if there is a better way?China Office:int 0/0 IP: 4.4.4.1/32int 0/1 IP: 5.5.5.1/32 (second ISP)US Office:Public ...
Hi all!I have an ASA 5510 (routed mode) which I am trying to use to route traffic between VLANs on the Management Interface.Currently:Eth 0/0 - Outside seclevel 0 publicly addressed IPEth 0/1 - Inside seclevel 100 trunk to stack of Cat3560 switches a...
Seems like Cisco may have missed the mark on this one. I too connect to many locations using the Anyconnect client, and have no control over the ASA configuration that manages their settings or deploys new versions. I am constantly having to enter ...
I should've known that even though the GUI ASDM complained about it and even though the CLI (via the GUI) complains about it but let's it go that it was possible.Spoiled by yet another GUI.Thanks Roshan
Thank you Paulo. I will definitely look into this as an option, one, because of the cost of MPLS, and rumors that MPLS as a technology is only finding limited success because of the requirements for individual connectivity (Hard if not impossible to...
Jon,Thank you for confirming my thoughts on this. Might you be able to provide me with some resources to learn more about MPLS and implementation?Thanks again!
Thanks m-haddad.That's what I've come to realize (again). I just haven't had to do this in so long. So my options are to create a tunnel (GRE or other) from each US source to the PEER and ISP2 owns everything between that point and the destination....
