About ITAdmin777

ITAdmin777 · 06-22-2016

Hi community, To make a long story short, I am attempting to configure a switch that I will need to deploy in one of our remote sites. ,I set it up the same as the other switches in that same remote site, so before running out to the site which is...

ITAdmin777 · 05-19-2016

Hello Community. My Cisco knowledge is limited but a work in progress! Can someone tell me the proper way to replace a switch in a stack. Please provide as much detail as possible. Example scenario, 3 switches in a stack with stackwise cables, ho...

ITAdmin777 · 05-03-2016

Hello community...need some clarification Does last configuration change show last change to the running config?...And Does NVRAM config last updated show last time running-config wrote to startup-config?So if a tech/individual made a config change ...

ITAdmin777 · 03-09-2016

ITAdmin777 · 02-20-2016

I am doing some research for 10Gbe for existing distribution switches back to our core switches. If anyone can chime in, very much appreciated...Cisco is not my strong point...but a work in progress! Here are the details if anyone can help validate...

ITAdmin777 · 06-23-2016

Thanks for your prompt response. Should have seen that. All is working!

ITAdmin777 · 06-23-2016

Thank you for the feedback...that did the trick!....sometimes the obvious is not so obvious! : )

ITAdmin777 · 02-21-2016

Hello Reza, Appreciate the guidance. I will do a little more research in our closet/patch panel. So to confirm I would require the following: 3750e:X2-10GB-SR's - 10GBASE-SR X2 transceiver module for MMF, 850-nm wavelength, SC duplex connector Pat...

ITAdmin777 · 03-13-2014

Hi Jon,I did as you suggested....and also came across another article that suggested doing the following on the XP workstation:On workstation command prompt type:netsh interface ip delete arpcache.Arp table show the correct Mac/ipI should know within...

ITAdmin777 · 03-13-2014

Well...looky what we have here? The user did have .22 yesterday and we assigned static (.19) this AM.sh ip arp | include 0016.e604.7b34Internet 192.168.41.19 9 0016.e604.7b34 ARPA Vlan41Internet 192.168.41.22 186 0016.e604...

Member Since	‎01-31-2014 09:27 AM
Date Last Visited	‎08-18-2017 04:01 AM
Posts	24

User Statistics

User Activity

Unable to ping or connect to switch while attempting to configure

Switch Stack maintenance - How to replace 1 switch in a Stack

Need Clarification on "Last Configuration Change" and "NVRAM Config Last Updated"

How to tell if a port has not been used in a while

Upgrade Uplink ports to 10Gbe

Thanks for your prompt

Thank you for the feedback..

Hello Reza,

Hi Jon,I did as you suggested

Well...looky what we have