Hi Leo, What confuses me is that the connection was working. I used the correct cable and the port type as well. How do i resolve this? ... View more

It worked after i changed i made vlan 99 a native vlan.   Thank you!!!! You're a star  ... View more

Not yet, i can't ping the servers. I have added the Nics to vlan 99 on the service profile template. That's the only thing left ... View more

Not yet, i can't ping the servers. I have added the Nics to vlan 99 on the service profile template.     ... View more

EMM-UCS-A(nxos)# show interface ethernet 1/15-16 trunk -------------------------------------------------------------------------------- Port          Native  Status        Port               Vlan                  Channel -------------------------------------------------------------------------------- Eth1/15       1       trnk-bndl     Po61 Eth1/16       1       trnk-bndl     Po61 -------------------------------------------------------------------------------- Port          Vlans Allowed on Trunk -------------------------------------------------------------------------------- Eth1/15       1,99 Eth1/16       1,99 -------------------------------------------------------------------------------- Port          Vlans Err-disabled on Trunk -------------------------------------------------------------------------------- Eth1/15       none Eth1/16       none -------------------------------------------------------------------------------- Port          STP Forwarding -------------------------------------------------------------------------------- Eth1/15       none Eth1/16       none -------------------------------------------------------------------------------- Port          Vlans in spanning tree forwarding state and not pruned -------------------------------------------------------------------------------- Eth1/15       -- Eth1/16       --       EMM-UCS-A(nxos)# show interface port-channel 61 port-channel61 is up   Hardware: Port-Channel, address: 002a.6a6f.e896 (bia 002a.6a6f.e896)   Description: U: Uplink   MTU 1500 bytes, BW 20000000 Kbit, DLY 10 usec,      reliability 255/255, txload 1/255, rxload 1/255   Encapsulation ARPA   Port mode is trunk   full-duplex, 10 Gb/s   Beacon is turned off   Input flow-control is off, output flow-control is off   Switchport monitor is off   EtherType is 0x8100   Members in this channel: Eth1/15, Eth1/16   Last clearing of "show interface" counters never   30 seconds input rate 2184 bits/sec, 273 bytes/sec, 1 packets/sec   30 seconds output rate 160 bits/sec, 20 bytes/sec, 0 packets/sec   Load-Interval #2: 5 minute (300 seconds)     input rate 1.73 Kbps, 1 pps; output rate 296 bps, 0 pps   RX     6487 unicast packets  9645844 multicast packets  436377 broadcast packets     10088708 input packets  915809390 bytes     0 jumbo packets  0 storm suppression bytes 0 giants      0 input error  0 short frame  0 overrun   0 underrun      0 watchdog  0 if down drop     0 input with dribble  0 input discard     0 Rx pause   TX     2 unicast packets  1131784 multicast packets  21362 broadcast packets     1153148 output packets  272571179 bytes     0 jumbo packets     0 output errors  0 collision  0 deferred  0 late collision     0 lost carrier  0 no carrier  0 babble     0 Tx pause   3 interface resets   EMM-UCS-A(nxos)# sho run int eth1/15-16 !Command: show running-config interface Ethernet1/15-16 !Time: Wed May 28 06:59:10 2014 version 5.0(3)N2(2.11.3a) interface Ethernet1/15   description U: Uplink   pinning border   switchport mode trunk   switchport trunk allowed vlan 1,99   channel-group 61 mode active   no shutdown interface Ethernet1/16   description U: Uplink   pinning border   switchport mode trunk   switchport trunk allowed vlan 1,99   channel-group 61 mode active   no shutdown   ... View more

Hi Wdey,   I'm lil confused there!!! It doesn't take the command    show interface ethernet 1/15 | port-channel 61 trunk 1 | vlan 99   Is that correct???   ... View more

Hi Wdey,   I tried that, still no changes, see the attached screenshots. Below is the output from the show interface:   EMM-UCS-A(nxos)# show interface eth1/15-16 Ethernet1/15 is up   Hardware: 1000/10000 Ethernet, address: 002a.6a6f.e896 (bia 002a.6a6f.e896)   Description: U: Uplink   MTU 1500 bytes, BW 10000000 Kbit, DLY 10 usec,      reliability 255/255, txload 1/255, rxload 1/255   Encapsulation ARPA   Port mode is trunk   full-duplex, 10 Gb/s, media type is 10G   Beacon is turned off   Input flow-control is off, output flow-control is off   Rate mode is dedicated   Switchport monitor is off   EtherType is 0x8100   Last link flapped 21:30:59   Last clearing of "show interface" counters never   30 seconds input rate 1576 bits/sec, 197 bytes/sec, 1 packets/sec   30 seconds output rate 72 bits/sec, 9 bytes/sec, 0 packets/sec   Load-Interval #2: 5 minute (300 seconds)     input rate 1.22 Kbps, 1 pps; output rate 144 bps, 0 pps   RX     3690 unicast packets  8690660 multicast packets  171390 broadcast packets     8865740 input packets  723784844 bytes     0 jumbo packets  0 storm suppression bytes 0 giants      0 input error  0 short frame  0 overrun   0 underrun      0 watchd og  0 if down drop     0 input with dribble  0 input discard     0 Rx pause   TX     2 unicast packets  565878 multicast packets  21336 broadcast packets     587216 output packets  142538564 bytes     0 jumbo packets     0 output errors  0 collision  0 deferred  0 late collision     0 lost carrier  0 no carrier  0 babble     0 Tx pause   2 interface resets Ethernet1/16 is up   Hardware: 1000/10000 Ethernet, address: 002a.6a6f.e897 (bia 002a.6a6f.e897)   Description: U: Uplink   MTU 1500 bytes, BW 10000000 Kbit, DLY 10 usec,      reliability 255/255, txload 1/255, rxload 1/255   Encapsulation ARPA   Port mode is trunk   full-duplex, 10 Gb/s, media type is 10G   Beacon is turned off   Input flow-control is off, output flow-control is off   Rate mode is dedicated   Switchport monitor is off   EtherType is 0x8100   Last link flapped 21:30:59   Last clearing of "show interface" counters never   30 seconds input rate 464 bits/sec, 58 bytes/sec, 0 packets/sec   30 seconds output rate 72 bits/sec, 9 bytes/sec, 0 packets/sec   Load-Interval #2: 5 minute (300 seconds)     input rate 504 bps, 0 pps; output rate 144 bps, 0 pps   RX     2691 unicast packets  946092 multicast packets  262803 broadcast packets     1211586 input packets  190929407 bytes     0 jumbo packets  0 storm suppression bytes 0 giants      0 input error  0 short frame  0 overrun   0 underrun      0 watchd og  0 if down drop     0 input with dribble  0 input discard     0 Rx pause   TX     0 unicast packets  565177 multicast packets  26 broadcast packets     565203 output packets  129867445 bytes     0 jumbo packets     0 output errors  0 collision  0 deferred  0 late collision     0 lost carrier  0 no carrier  0 babble     0 Tx pause   2 interface resets EMM-UCS-A(nxos)#     ... View more