Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi everyone, Is there any way to control the packet loss measurement for SLM/Y1731 on ASR9k? For example, I have created a probe to send 60 packets every second, but it happens I lose one packet, therefore the packet loss would be 1/60=1.67%, which ...
Hi, I am testing a MPLS L3vpn scenario with a Route Reflector in the middle to reflect vpnv4 routes between PEs. But not only reflecting the routes also to participate in forwarding plane as well. For this I forced to change the next hop to Route Re...
Hello, ASR9001 is rebooting itself continuously. The only thing that Ive notice so far is that the line card module stuck on MBI Running. ASR9001-LC MBI-RUNNING Also I see this log too wdsysmon[457]: %HA-HA_WD-4-DISK_WARN : A monitored device /d...
Hello all, Im showing some weird logs on ASR9001, it seems to me a memory leak due to pm_collector process. what is this process and will the restart of the process resolve the issue without impacting the services? pm_collector[]: %LIBRARY-REPLICATOR...
Dear All,
Recently, I am using a lot of ME3600-x and I have applied MPLS on my network. I am having trouble passing bpdu packets from one Customer's site to another site.
So, at end devices (cisco switch 3560), I have configured the ports where cust...
Thank you so much for your helpful support. So by using now two probes per bucket it lowered somehow the packet loss Bucket started at 17:50:47 EDT Fri 27 March 2020 lasting 2minPkts sent: 120; Lost: 1 (0.8%); Corrupt: 0 (0.0%);Misordered: 0 (0.0%);...
Thank you for your response. So does this mean I can calculate based on a threshold? So If I have above 30% of packet los ASR9k can start reporting it? And if I have less then 30% packet loss, it will not count that loss? When aggregation is enabled ...
Cause these PE-s have limited number of LSP. So for a topology like 200 PEs they will not support it and I thought to concentrate the traffic on RR-s(cisco routers) so at least they would have to build one LSP to RR only and not to each of PE Thank...
Yes sure. Actually the BGP sessions are up so I have reachability to RR, anyway pasting here the output PING 1.1.1.1: 56 data bytes, press CTRL_C to breakReply from 1.1.1.1: bytes=56 Sequence=1 ttl=63 time=11 msReply from 1.1.1.1: bytes=56 Sequence=2...
