Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello World
basically I've got 2 internet connections on the same 881 router.
I want my lan to use wan 1 but a specific host on the same lan to use wan2.
wan 1 is a physical interface fa4. Wan 2 is a vlan with a static ip address assigned to one of ...
We have purchased some additional external IP addresses from our ISP as we've used all the statics on the external inferface of our ASA5525
So I now have 2 blocks of IP addresses, the first is configured on the external interface and I need a way o...
I'm looking for some guidance on adding a splash page to a network secured by a pre shared key.
Ideally the splash page will be a simple 'click through' i.e. the users will connect to the ssid using the psk. When they first try to browse they will re...
I have an issue with an 1941 router - I am unable to get the SSL VPN working.
I believe the router should be enabled for SSL as its on the Version 15.3(3)M7 IOS. This should have the RTU license feature. Is there a way to enable this for the SSL VPN?...
Looking for some guidance on the correct configuration for inbound NATs with various ports due to SIP requirements.
basically i have a free IP address out of my static external range - i don't want to add a dozen ip nat inside source static lines in...
yes, typo! route map is correct in the config...
and secondly ... in context, how would you suggest it looks? (I've tried some variations but on the same route-map)
I've tried with
route-map test permit 10 match ip address test set ip next-hop y.y.y...
The output of the show license feature command is below -
showlicensefeatureFeaturenameEnforcementEvaluationSubscriptionEnabledRightToUseipbasek9nononoyesnosecurityk9yesyesnoyesyesdatak9yesyesnonoyesNtwkEssSuitek9yesyesnonoyesios-ips-updateyesyesyes...
If your right I'm not sure what I'm supposed to be telling the router - what WORD?
Router#license right-to-use move ? WORD license name
I've been advised by the license reseller that I don't need to load any licenses onto the router.
I think its a little more complicated that that -
I was thinking a little more like the below - I can have a static external ip address designated for SIP, but from inside I can be very specific about the outbound ports that I nat to the external ip...
1941 router - one interface external, one internal. I'd like to have incoming nats and out going nats on then same, currently spare, ip address from then external range.
