Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,This VG 224 is right out of the box and during the booting it displays these errors.% Crashinfo may not be recovered at flash:crashinfo% This file system device reports an errorThen when I tried to take a look at the flash it di...
I have to add lilnes to a VG 224 but I don't want to interupt service so if I click on the "Apply Config" to add the numbers will it restart the VG or just make changes to that FXS port?
Is this what a an initial startup of a vg 224 should look like. It's an older version but it just frezzes once it gets to the point when it asks if I would want to configure it. Is there anything that seems off?System Bootstrap, Ve...
Please see my modem recovery config belowIf I change rssi onset-threshold to -60 would th modem try to automatically reconnect to the provider?Is there other way I can improve the modem link recovery setup in case of poor connections? c...
CLI= "Utils System Restart" HTTP = Step 1 From the Cisco Unified Communications Operating System Administration window, navigate to Settings > Version. The Version Settings window, which shows the software version on both the active and inactive part...
Just calling 911 in NY is not ok. You must go through the appropriate channels to test. I have tried before and have gotten very distraught operators that insist you must go through the correct procedure.
Carlo,thanks for the info but I did try that and I found this It does not affect any functionality of the router. It only cautions the user about unrecoverable crashinfo, so that user may configure other modes of collecting the Crashinfo. Please con...
