Hi - We have ASA 5516-X firewall in our infra; we have a requirement to allow any service from vulnerability scanner to scan the ASA firewall device.
What is the way to allow this traffic as we cannot use interface ACL to restrict the acccess
Re...
Hi - I am currently implementing AAA server (ISE) in our infra and i would like to configure in such a way that; line vty aaa can be done via tacacs server. But the console access will be only to local authentication.
Please let me know the best wa...
Hi - I would like to know if a communication can happen betwteen 2 subnets which are part of same VLAN.
Switch config:
***************
interface vlan 440
ip address 192.168.51.1/22
ip address 172.31.0.1/21 secondary.
We have 2 servers one belongs to...
Hi - I have been trying to create one user account with less privilege who has access to run "show running-config" without "view full" command to view the complete output for taking device backup. I tried parser view, but still show runn does not giv...
Hi - I would like to know if its possible to enable stack-wise port monitoring through SNMP server.Like stackwise port flap, down, etc status monitoring to enable alerts in our syslog server.If anyone knows, please let me know. thanks
Thanks Karsten, unfortunately that is not practically possible for all 65535 service and that too both TCP & UDP.
Is there anyway i can give "any" service for those scanner IPs to scan the Firewall.
No, still same case "show run" shows only below output. But show startup shows complete output.
show running-configBuilding configuration...
Current configuration : 195 bytes!! Last configuration change at 12:45:03 CET Tue Mar 7 2017 by ***! NVRAM c...
Thanks Julio for your reply.
My requirement is a local user with privilege level 7 should execute the command "show running-config" to view the complete output of the "show run". Please let me know if you have any other way to do it.
