About oldvoffka

oldvoffka · 01-22-2012

OSPF adjacency is not established. HELP.router1(X)async1/10----[modem1]------leased line------[modem2]----Serial0/2/2(X)router2 router1#sh ver Cisco IOS Software, 2800 Software (C2800NM-IPBASE-M), Version 12.4(8a), RELEASE SOFTWARE (fc2) Technical Su...

oldvoffka · 01-22-2012

Oh!!! It's great? after configuring command "async default routing" on both serial and async interfaces, OSPF adjacency establishedrouter2#sh ip ospf neiNeighbor ID Pri State Dead Time Address Interface10.105.254.194 ...

oldvoffka · 01-22-2012

oh i am sorry, there was a mistake! there is on on side (router1 async interface):Hello due in 00:00:05but on other (router2 serial interface in async mode) No Hellos (Passive interface)But on router1 on other async interface OSPF works.

oldvoffka · 01-22-2012

1)router2#ping 10.5.253.117Type escape sequence to abort.Sending 5, 100-byte ICMP Echos to 10.5.253.117, timeout is 2 seconds:!!!!!Success rate is 100 percent (5/5), round-trip min/avg/max = 176/206/227 msrouter2#2) leased line - it is only 4-wired l...

Member Since	‎01-22-2012 10:39 PM
Date Last Visited	‎08-18-2017 03:51 AM
Posts	4

User Statistics

User Activity

OSPF adjacency is not established.

Re: OSPF adjacency is not established.

OSPF adjacency is not established.

OSPF adjacency is not established.