Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello everyone,I would like to configure route damping on two routers, each receiving Internet routing table from two separate eBGP neighbors.We are a Cloud service provider, so obviously route stability matters and that's why we were thinking of imp...
Hi,
As far as I know, reloading the vdc is optional, you can check if everything is going well after the rebind interfaces with show vdc detail.
In case you are creating a new VDC, then you can only reload the new vdc with reload vdc NEW.
I assume th...
Hi,
an output of show run, excluding any possible sensitive information, would be helpful.
As a checklist, make sure you have defined correct IP addressing, NAT, access-list and security-level, plus interface zone definitions.
One question, do you wa...
Hi,
I'm more suspicious of a Layer 1 issue. Check the transceivers and the links between chassis. To rule out some possibilities, you can try swapping the transceivers, swapping the ports, etc.
Also a show run of the VSS configuration would be helpfu...
Hi,
If you really wanna make it so complex, then create a SVI for VLAN10 on SW2 and assign an IP address in the same subnet. Use that IP as the default gateway for the server.
Then, you also have to add a default route on SW2 having firewall as nexth...
