About Terence Payet

Terence Payet · 04-21-2016

Hi all, I work in a small ISP and in the process of migrated some services to a 7600 router with the above card installed. I want some clarifications regarding the EVC configurations on those specific line cards. Let say we have over 5000 customers...

Terence Payet · 07-12-2015

hi expert, seeking your great advice on the below scenario:I work in small ISP and we provide internet over DSL and point to point internet as well.We have a cisco SCE in which we use to control customers bandwidth and monitoring. The thing we are fa...

Terence Payet · 05-18-2015

Hi expert, I want to configure option 43 on a cisco 4500, and wanted to know on how to go about it.Basically I want to include a URL of a management server + username and password.note that the dhcp server is on the 4500. thanks in advance. regards, ...

Terence Payet · 04-21-2015

Hi expert, This might be a stupid question.See below scenario:Let say i have two access switches connected on 1 router with one vlan, and i want to run some sort of redundancy protocol such as HSRP on the router for that vlan using some sort of vrf c...

Terence Payet · 04-21-2015

Hi expert, This might be a stupid question.See below scenario: Let say i have two access switches connected on 1 router with one vlan, and i want to run some sort of redundancy protocol such as HSRP on the router for that vlan using some sort of vrf ...

Terence Payet · 07-05-2018

Hi Gokul, I don't think there's any other way to achieve failover with static routes. If you want to implement failover with other criteria such as link utilisations etc.. The only thing in mind is PfR (Performance Routing). But PfR is two way, so ...

Terence Payet · 06-27-2018

Hi, DO you have two vlan's on your LAN meaning is the LAN subnet (192.168.1.0/24) configured on the other working router same as the new router? If so this might be the issue. Can you post the config of the other working router? Can you share a bri...

Terence Payet · 06-27-2018

Hi, Basically the next-hop (20.1.1.1) towards the final destination was not present in the RIB on Router A. So by redistributing connected on Router B advertised the next-hop interface in RIP. HTH. Regards, Terence

Terence Payet · 06-27-2018

Hi Norbert, Since you have OSPF neighborship with all your branches. You have three options from CORE: Under ospf process issue "default-information originate" - This will check the RIB for a default route and if it is present, it will advertise ...

Terence Payet · 01-17-2018

Hi, Will be great if you can share the BGP topology in terms of AS-PATH between the hub and the spokes so that we can help further. As for the 'bgp multipath as-path ignore' it is available on older platforms, but it is a hidden command so basicall...

Member Since	‎04-02-2012 11:42 PM
Date Last Visited	‎01-25-2023 12:39 AM
Posts	130
Total Helpful Votes Received	76

User Statistics

User Activity

EVC config on ESM20G card

QOS strategy WAN - 7600

Option 43 configuration L3 Swit

HSRP + VRF Lite

VRF LITE with HSRP

Re: Failover between static routes

Re: Cisco 867VAE –k-w-9 and FTTC WAN configuration

Re: BGP route advertised but unable to ping

Re: Distribute alternative default route, OSPF?

Re: Load Sharing with different as-path length