Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I need to setup the codec pro with 2 monitors connected (HDMI 1 and 2).I want this to achieve:1. When in call (no prensentation), local camera view will show in monitor 1 and far end in monitor 2.2. When there is presentation, local camera view and f...
Hi,We are integrating VCS Control and CUCM via SIP trunk for video endpoints registered on the VCSc and IP phones registered on the CUCM to be able to communicate.VCS endpoints dial plan: 49xxCUCM IP phone dial plan: 797xxxxIP address of CUCM peers: ...
Hi,We have deployed VCS Control with VCS Expressway for firewall traversal and encountered issue. On the VCSe call status, it says 403 forbiddenwhen an external endpoint registered as SIP on the VCSe will initiate a call to an internal endpoint regi...
Hi Patrick,I tried to set the profile zone to Custom and now it works fine. We fully established the connection between CUCM and VCS. Calls from IP phone on CUCM to video endpoint on VCS and vise versa is working well.Just to share the VCS configurat...
Hi Daniel,Thank you for some inputs and recommendations.Default Zones, subzones authentication policy on both VCS are set to "Check credentials" except for Traversal zone set as "do not check credentials/treat as authenticated" on the servers.Yeah, y...
Hi Patrick,All authentication should be on the VCS Control. No zubzones yet for Jabber users.Do we need to create subzones for jabber users on the Control or in Expressway?Thanks,Acevirgil
Hi Patrick,On the VCS Control:Default subzone: check credentialDefault zone: check credentialTraversal zone: check credentialOn the VCS Control:Default subzone: do check credentialDefault zone: do check credentialTraversal zone: do not check credenti...
