Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello all, I am trying to configure up a 2911 via the following link... http://www.cisco.com/c/en/us/support/docs/security/flexvpn/115014-flexvpn-guide-cert-00.html(AnyConnect to IOS Headend Over IPsec with IKEv2 and Certificates Configuration Exampl...
Hello all,We have a Site-to-Site VPN that is securing all traffic to/from 10.160.8.0/24 to/from 10.0.0.0/8. This is for everything - including Internet traffic. However, there is an exception (of course)...The part I cannot get working is if traffi...
Hello all,Setting up iSCSI boot for the first time and had a question.Setup: UCS blades connected to a N5K pair (vPC) with a dual-controller NetApp connected. There are 4 UCS vNICs - two for just iSCSI (as the native VLAN) and two for everything el...
Thanks Marcin. Yeah, it is our OOB router so only about 4 people will be using it - not large at all. I would have used another router as the CA but it is the only IOS router in the install (everything else is running NX-OS) Do you have a good l...
Thanks Brendan!Fixing the netmask was good (doh!! oh my part) but changing the NO-NAT ACL from deny tcp (with a port) to a deny ip did the trick.Thanks!
