Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,
Is it possible to use tacacs+ and TrustSec on the same device?
I think that configurations of tacacs + can not set several TrustSec configurations.
For example, pac key etc.
The AWS settings were the same.The cause was a bug in MX 19.2.7.Upgrading the version resolved the issue, and the IPsec SA establishment was successful.
The encryption settings on the Meraki side are as follows:Using IKEv2[Phase1]Encryption: AES-256Authentication: SHA256Diffie-Hellman group: DH Group 14Lifetime(seconds): 28800[Phase2]Encryption: AES-256Authentication: SHA256Diffie-Hellman group: DH G...
Thanks Philip.The Meraki version is 19.2.7.Phase 1 is marked as Established, but Phase 2 remains "down" and doesn't change to UP in my environment.CloudWatch logs show that AWS tunnel received a Phase 2 SA DELETE message from Maraki.In addition to th...
I'm also experiencing a same situation where Phase 2 of Meraki and AWS BGP over IPsec connection isn't going up.Are there any settings I should be aware of on the Meraki side?The AWS VPN connection's Traffic Selector is set to 0.0.0.0/0 for both Loca...
