Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
HiOtherday we had a problem with my FWSM. There were huge no of xlate connections shown in the firewall. Traffic was not going through, interfaces were in hung state, had to reboot the FWSM beside blocking the IP Addresses from where the huge number ...
Hi Friends,I have Cisco 1140 access points and 5508 controller in my network. I have configured 2 SSIDs. One SSID is working fine, we have issue with second SSID. Clients getting connected to second SSID are facing the latency issue, latency is aroun...
Hi ,I have 7600s in my network. The traffic statistics on my SVI interface doesn't corresponds to the traffic respective to physical ports. Assume i have four physical ports with access vlan 100. The traffic on interface vlan100 should be sum of traf...
Hi Friends,Iam trying to configure MQC based qos on my Cisco 3750 switch. The switch accepts all commands, however when i apply the service policy to the interface it doesn't have any effect. I don't see any matching packets with show policy-map comm...
Hi Friends,Iam trying to configure MQC based qos on my Cisco 3750 switch. The switch accepts all commands, however when i apply the service policy to the interface it doesn't have any effect. I don't see any matching packets with show policy-map comm...
ur trying to suggest there is problem in the wired network but not the wireless part. Iam a data guy have ensured there is no problem in this portion. need to look at if some of the features in the wlc related to ssid or vlan etc can be enabled/disab...
