Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi experts, My customer wanted to connect 2*100G link in Inter-DCI link. we are using vxlan multisite setup. Hence the 100G link will be terminate to BGW leafs in both the DC. My question is Cisco nexus switches supports 100G only in uplink ports. It...
Hi All,Im trying to setup BGP between Nexus9K vxlan vPC fabric peering with NCS560.The problem Im facing is when vPC from BL1 goes down the BFD and BGP is not going down. why ? because the BL2 Path is up and NCS560 sending the BFD and BGP hello packe...
Hi Experts, Im deploying NDFC for greenfield network. In resource tab its asking below, i don't know what this will be used for , should i keep it default value or I need to put some vlan and need to reserve it .* Network VLAN RangePer Switch Overlay...
Hi Experts,
we have L2 EVPN vxlan fabric. our multicast source is connected on VTEP-1 and receivers are connected ion VTEP-2.
Both source and receivers are connected via access switch(L2) to vxlan network
i can see IGMP group on access switch but n...
Hi Experts,
we have l2 vxlan evpn network.The l3 of the end-host is configured on nexus7k.what we notice that the end-host not able to reach to gateway I.e VIP HSRP.
When we clear the ARP on the gateway it started working.
My question is if ARP supr...
Thanks Balaji, Indeed nothing needs to be done. Just connect the SFP and cable and port comes up, its takes some time for NDFC and needs two deployment trigger.
Hi All, 1) Just wait for sometime, if deployment lines are more NDFC takes some time to show deploy , personal experience :).2) if the leafs are BGWs, hope you are doing from parent fabric not child fabric. 3) Dont try to do recalulate and deploy aga...
Hi @ex-engineer , we have deployed MSD vis BGWs , you can have BL and BGW on the same leaf, the only thing you might need to consider is that the vlans which you will extend you will deploy in BGWs so the capacity is one thing you need to consider. B...
Thanks for replying, we are using N9k-C93180YC-FX3, all the downlink and uplink ports falls under same asic 0. I guess it uses different type of architectureBL1# show interface hardware-mappingLegends:SMod - Source Mod. 0 is N/AUnit - Unit on which p...
Thanks Balaji for your response.I was not sure on your diagram short and Long, can you elaborate to get more clarity ? - Its DWDM links one long and other small to connect the inter DC l, we are going to built BGW square box topology and will use 10...
