Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello, We are trying to adjust the channel width on the 5GHZ radio for our 1602i Autonomous AP's Currently using the 20mhz channel width on 5GHZ however when we try to change it on the Web GUI it just gives us an error 404 page not found on any brows...
Hello, Recently purchased 3 of these units and have them working fine, however I am receiving terribly slow transfer speeds from any server, or storage device I try to send or receieve. Fastest I can get is 2.5MB/s or 20Mb/s on all three. Very basic ...
Here is the commands i've ran and it seems to work, however trying to reboot the AP in the GUI doesn't seem to work. Just want to make sure the configuration is being saved properly. What is the command to reboot? enableconfig tint d1channel width ...
Hello, Sorry to dig up an old topic but this problem is still happening. I have just ordered an additional one of these as our wireless continues to grow, which it should have the latest firmware so we will see if that helps. Here is the latest confi...
Still having the issue. Here's the config file: no service padservice timestamps debug datetime msecservice timestamps log datetime msecservice password-encryption!hostname ap1!!logging rate-limit console 9enable secret 5 $1$0O/f$3da6LZAT28Go5ga8WYIb...
