Aironet 1602I

[rustydusty1717]

Hello,

We are trying to adjust the channel width on the 5GHZ radio for our 1602i Autonomous AP's

Currently using the 20mhz channel width on 5GHZ however when we try to change it on the Web GUI it just gives us an error 404 page not found on any browser/computer we use.  Attached is our config (Removed SSID and some other info that shouldn't matter)

[Rasika Nayanajith]

Simply access AP via CLI and you can make that change easily & save config (copy run start or we mem)

AAP1(config-if)#channel width ?
20 20 Mhz width
40-above 40 Mhz width with extension channel above
40-below 40 Mhz width with extension channel below

HTH

Rasika

*** Pls rate all useful responses ***

[rustydusty1717]

lb1>channel width ?
% Unrecognized command

[Rasika Nayanajith]

first you have to go to enable mode & then to config mode

ap>enable

ap#config t

ap#int d1

ap#channel width

HTH

Rasika

[rustydusty1717]

Here is the commands i've ran and it seems to work, however trying to reboot the AP in the GUI doesn't seem to work.  Just want to make sure the configuration is being saved properly.  What is the command to reboot?

enable
config t
int d1
channel width 40-below
end
copy running-config startup-config

[Rasika Nayanajith]

simply issue "reload" command

Rasika

[rustydusty1717]

If we want the radio to run at 40mhz do we specify the 40-below or the 40-above option?

[Rasika Nayanajith]

Either would work. Only used that with 5GHz band (radio 1)

HTH

Rasika