Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have an RV320 and I would like to upgrade the firmware. My current firmware is 1.2.1.14. The most recent FW is 1.5.1.05. Can I direct upgrade the FW or do I have to upgrade in steps? Thank you in advance.
I am considering purchasing three RV345 VPN routers to setup a 3 site network. I read a review that complained that the VPN feature required an additional license. Does anyone know what this additional license is and it's cost?
I have 3 sites that I need to network together. My primary reason for this is to allow anyone to print to any location from any location. I am looking for the best practice for this. My plan right now is to use an RV320 at each site and have two ...
Hi there. I am a neophyte when it comes to using Cisco Enterprise grade products and I could use some help. I have a current need to setup some outgoing FW rules and I don't know where to go to set them. Specifically I want to "add a rule that all...
Hi There. I want to set up a VPN for my customer. The customer has an ASA 5505 and it is conncted to a Windows Server 2003 network. Now I know that Windows 2003 can be used for a VPN and it appears that the ASA can also be setup to host a VPN. If...
Thanks for the input. The sites are less than 10 miles apart so I don't think that I have to worry too much about delay. I guess my fear or concern is a looped connetion route. With a simple hub-spoke topology, the path to any resource is clear...
A bit more about the application. This is a 3 location real estate company. In total they have about 25 agents but only 4 or 5 full time employees (1 or 2 at each site). Their main goal in implementing this is to be able to print to any printer f...
Thank you for your response. So for a mesh vpn config, I would have 3 VPN's as is shown below. Site A to Site B (VPN #1)Site B to Site C (VPN #2)Site C to Site A (VPN #3) What difference will users experience if I don't add the 3rd VPN (above)...
Thank you. I just want to make sure I understood. The solution will have two VPN'sSo site A is connected to Site B via VPN (VPN #1)And site B is connected to Site C via a VPN (VPN #2)As long as I configure it for the Local Security Group as subnet ...
The ADSM GUI.Thank you for your response. I think I understand what you said. The key thing (if I understood it correctly) is that ALL traffic is allowed by design from the higher to lower security levels (i.e. inside to outside interface). Th...
