Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Dear Communtity,
I am currently struggling in a stage where the end user connects to the Flex SSID and redirects to the Authentication Portal to Cisco ISE without using the Central Web Auth of the Cisco WLC 9800 . I have created Flex Redirection ACL ...
HI,
We have 2 Cisco WLC 9800 40
We have some APs 9130AX.
We have configured HA between 2 WLCs....
Both SP port connect with POE Switch. and PR ports connected with WLC together..
When i connect the APs to the Switch, but unfortunatly can't..
All Dev...
Hi All,
Please find the attached, we are using OSPF on Core and distribution switches, all desktop/laptop users are connected with access switches.
My proxy server is also mentioned separate.
Question : local traffic is going from end user to distr...
Hi,
we have configured nexus 9k switch and connect directly with DELL EMC unity 300, we are unable to ping connectivity, also configuration below mentioned.
vlan 101
interface vlan 101
ip address 10.0.0.1 255.0.0.0
no shut
interface ethernet 1/1
s...
Hi, Thanks for feedback.
Please see the layout design.end users are connected below Aggregation switch which is ospf area 10.1) local traffic will forward from aggregation to core switch.
2) if any user want to go on the internet so the traffic will ...
Can the EMC ping other hosts on the same subnet : YES
When we configure the layer ip on nexus switch. now we can able to ping.
when we configure layer-2 port with vlan on nexus now interface is up. but can not pinging..
