About heleon

heleon · 02-27-2017

Hello Team We have a problem to stablish a nV Edge Cluster between a pair of ASR9006. We have followed the procedures: https://cloudsso.cisco.com/idp/startSSO.ping?PartnerSpId=https://techzone.cisco.com/auth/saml&redirectreason=notregistered&TARGET=...

heleon · 02-20-2017

Hello Experts I have attempted to install the sp4 (asr9k-px-5.3.3.sp4.tar)for IOS XR 5.3.3 in AR9006 However the install fails with a message about the state of 0/RSP1/CPU0. Can I install the SP4 in spite of the status of 0/RSP1/CPU0? Thanks in adva...

heleon · 02-28-2017

Hello Team I connected all the consoles and I could see that while RSP0 was sending the messages indicated above the RSP1 was with prompt rommon1> After a review of the environment variables the cluster finally bring up. Hope this helps to another f...

heleon · 02-27-2017

Hello Aleksandar We are re-creating the customer's cluster in Lab in order to test some traffic scenarios. Thank you for your comments Hector Leon

heleon · 02-23-2017

Thank You! We removed the RSP1 and installed the PIE and SP. Also we requested the replace and we will install the new RSP1 as soon as possible. Thank you again for your valuable help and comments. Best regards

heleon · 02-22-2017

We will replace the RSP1 Best regards

heleon · 02-22-2017

Hello Team I used Cisco power calculator and two Power Supplies with 3000W it should be enough. Below the logs after re-seat the RSP in bringdown. Thanks in advance. RP/0/RSP0/CPU0:Feb 23 19:47:32.932 : shelfmgr[410]: %PLATFORM-SHELFMGR-6-NODE_STATE...

Member Since	‎03-19-2014 05:52 PM
Date Last Visited	‎02-19-2021 12:32 AM
Posts	11

User Statistics

User Activity

nV Edge is not established , Rack1 Stuck in Boot Image validation request

ASR9K install add fails when 0/RSP1/CPU0 is in bringdown state

Hello Team

Hello Aleksandar

Thank You!

We will replace the RSP1

Here are the logs