Hi all.I have problem for configure dot1x and authentication interface command in a switch universal 2960x, the switch indicates that the command does not exist, inclusive when lan base license is in use and active. switch(config-if)#int gigabitEthe...
Dear.
I have a query regarding fabric path and its operation in a specific topology (attached file).
They are 4 Nexus, which are separated into two pairs each linked with two links, in addition each pair has VPC +. The servers are connected to the ...
Estimados.
Tengo una consulta respecto a fabric path y su funcionamiento en una topología en específico (archivo adjunto).
Son 4 Nexus, los cuales están separados en dos pares cada uno enlazados con dos enlaces, además cada par tiene VPC+ , los serv...
HiI don't know interpret output command show ip traffic, could you tell me if the traffic is normal on catalyst 6500 ?#show ip trafficIP statistics: Rcvd: 413261306 total, 78451461 local destination 0 format errors, 0 checksum errors, 3465...
Hi peopleI have a problem with drop packet in many interefaces of a WS-C6506-E (R7000) (s72033-ipservices_wan-mz.122-33.SXJ3.bin)in the picture you can see thatmost of the interfaces have connected serverswhich can be the cause of this?, what trouble...
Thank for you response aninchatYes, these drops increment in bursts and then stay estable for a while, just as you say Below are output command show counter, show queueing, show module, show interface vlan 30 #show counters interface g1/2164 bit coun...
mm I don't know what kind of clable they are using, but should be cat 6, beacause the interface are Gi, therefore the speed is 1000Mbps.the biggest problem is many interface with output drop packet and all same vlan, but other interface in diferent...
GigabitEthernet1/39 is up, line protocol is up (connected) Hardware is C6k 1000Mb 802.3, address is 0018.bad2.5f18 (bia 0018.bad2.5f18) Description: ** netprovider(10.1.9.103) ** MTU 1500 bytes, BW 1000000 Kbit, DLY 10 usec, reliability 255/25...