Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi everyone
Is there a way to make CP-7911G send FQDN in the SIP register message.
Currently, A record IP address of the FQDN specified in the configuration is sent in the register request message, e.g. 1000@xxx.xxx.xxx.xxx, is there a way to make...
Hello everyone stop-timer policy action does not commit into policy, help shows it, it gets accepted, commit does not complain, it simply will not appear in the policy, this is xr512. It won't even 'show config' before `commit`.is this a known issue...
Hi guys,by any chance you might know what are IPC-WATERMARK/ICC-WATERMARK log messages, I googled, everything points to the fact that they are cosmetic, which is not the case, as SIP-400 stops passing traffic, sometimes even directly connected, until...
Hello everyone, What would be the best way to achieve link/cluster redundancy into the access plant given the second diagram? What is the best practice for redundant BNG configuration?Cluster is a couple of ASR9001 with a 2 port 10gbps line card in e...
Hello, which one of the many inputs and which receiver would you recommend for GPS.Will this work?http://www.microsemi.com/products/timing-synchronization-systems/accessories/communications/58534a-gps-timing-antenna Thank you in advance RegardsElnur
trying to do authorization against realm specified, I've tried "name" and "authname", with and without proxy/CM, i.e. I've tried everything I could think of, most of the combinations did not even attempt to initiate register, others which initiated, ...
Hi Xander,Please advise about 'Multicast and video distribution', is it implemented for IP sub sessions?I was able to find info for PPPoE, but not for IP sub sessions. Thank you Elnur
Hi HristoUgly is the key in here. Seems like QPPB is targeted at transit tier, that's where it's elegant. Elegant QPPB would be beneficial at any tier, then again what do i know:)CheersElnur
thank you for your honest answer:) good man!ACL with ~1k routes that needs to be maintained somehow (manual/script)seriously count me in for this to be implemented, it makes life much more easier, adds flexibility, almost magical:) what is the purpos...
I guess this is due to a hardware (FPGA/ASIC) limitation somewhere, otherwise, honestly, does not make sense to me.my concern is all our subscriber phy is 1Gbpsif not too much trouble for you, please advise a different method, how can I limit upstrea...
