Hi,   Im troubleshooting a messy wifi enviroment. We're using 3602I all the way, on version 7.6x Users are experiencing that the wifi is dropping, however the client numbers on the AP remains steady, however i've come by this statistics below: I've asked local support to try and ping their default gateway when this happens, but i've yet to hear from him. RF Counters Tx Fragment Count 212784754 Multicast Tx Frame Count 8093620 Tx Failed Count 3149560 Retry Count 9521658 Multiple Retry Count 1787587 Frame Duplicate Count 0 RTS Success Count 22884959 RTS Failure Count 34587092 ACK Failure Count 4268994575 Rx Fragment Count 0 Multicast Rx Frame Count 0 FCS Error Count 23435678 Tx Frame Count 213284161 WEP Undecryptable Count 15738   We're using flex connect APs and the CAPWAPtunnel has been up as long as the AP have been up. However i feel that this statistics seems quite high? Correct me if I'm wrong.   Any ideas on what may cause this? ... View more

Hello, Have anyone encountered this message being spammed in the loggs?  Aug  8 09:37:36: %SYS-5-CONFIG_I: Configured from console by vty0 Aug  8 09:38:28: %SYS-5-CONFIG_I: Configured from console by vty0 Aug  8 09:39:18: %SYS-5-CONFIG_I: Configured from console by vty0 Aug  8 09:40:14: %SYS-5-CONFIG_I: Configured from console by vty0 Aug  8 09:41:10: %SYS-5-CONFIG_I: Configured from console by vty0 Aug  8 09:42:05: %SYS-5-CONFIG_I: Configured from console by vty0 Aug  8 09:42:58: %SYS-5-CONFIG_I: Configured from console by vty0 Aug  8 09:43:55: %SYS-5-CONFIG_I: Configured from console by vty0 Aug  8 09:44:52: %SYS-5-CONFIG_I: Configured from console by vty0 SE008900sw01#term mon SE008900sw01#sh users     Line       User       Host(s)              Idle       Location *  1 vty 0     xxx     idle                 00:00:00     x.x.x.x   Interface      User        Mode                     Idle     Peer Address Of course this is normal behaviour if you're using the vty's, however this happens when no one is accessing the switch from the vty's. Im leaning towards either some background-task is issueing this configmessages or some kind of bug.  Have anyone else encountered this? ... View more

Hi! Is it possible for all accesspoints that is configured as lightweight from a WLC to LIST all accesspoints that is not assigned to a flexconnect group? I would actually love to know if its possble both from the GUI Prime / WLC and the CLI. I've tried to figure this one out myself, however I'm stuck. Its not hard to setup groups etc, its just the list AP that isn't assigned to a flexconnect group that I find troublesome. Anyone? :) ... View more