Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello Guys!
We received from a client a network design and part of it we didn't get why they used two switch between the two levels of Firewalls (see attachement).
Can anyone explain why they went that road ?
Best regards.
Hello, From my understanding of what should be in a topology table I think some routes are missing please help me understand.fo the subnet 192.168.8.0/24 sholdn't they be two routes in the topology table ? R7#sh ip eigrp topologyIP-EIGRP Topology Ta...
Am trying to make OSPF works over 4 routers but one of them always end up not working (DROTHER) here is my topology is it a normal behavior or something ?
Hello all! I set up a GRE tunnel. traceroute between tunnel interfaces : OKtraceroute between LANs interfaces : NOT OKHere is my setup : (in the attached picture)R1Tunnel0 is up, line protocol is up (connected)Hardware is TunnelInternet address is 10...
Hello please look at this :Switch#show ip int briefInterface IP-Address OK? Method Status Protocol Ethernet7/1 unassigned YES manual down down Ethernet8/1 unassigned YES manual down down Ethernet9/1 unassigned YES manual down down You can see that my...
Thx for your answer, but under my serial interface s0/0/0 I did this R1(config)#int s0/0/0R1(config-if)#enR1(config-if)#encapsulation ppp ? then the interface went down and when I did the same thing for the neighbor router interface it did came up bu...
you are right I just checked and my last router is using a broadcast network instead of point-to-point!but I did not change the type I just dragged and dropped it there hence I have 3 questions: why is it using broadcast instead of point to pointhow ...
Hello, The same thing!R7#sh ip eigrp topology all-linksIP-EIGRP Topology Table for AS 1 Codes: P - Passive, A - Active, U - Update, Q - Query, R - Reply,r - Reply status P 192.168.7.0/24, 1 successors, FD is 2816via Connected, GigabitEthernet0/0P 192...
Hellohere is the output same result !R7#sh ip eigrp topology all-linksIP-EIGRP Topology Table for AS 1 Codes: P - Passive, A - Active, U - Update, Q - Query, R - Reply,r - Reply status P 192.168.7.0/24, 1 successors, FD is 2816via Connected, GigabitE...