Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi I am using a Barracuda NG Firewall for firewalling and I would like to use a Cisco ASA 5505 for the Client VPN Connections. But I have the problem that I can't get a connection from the VPN connected PC to the internal network. But I can reach t...
Hi,I just configured Cisco Ayconnect. I can connect via Client VPN. My setup is a little bit differently (check the first picture of the setup).I am using a other Firewall in front of the Cisco ASA. The ASA is only using the inside interface and is o...
Hi,I would like to configure on my IOS Router a IPsec Client VPN and connect to it with any connect.Is it possible to configure a IPSec and SSL Client VPN on a IOS router ? I am using a 1841 for example.It would be perfect to give the user the choice...
Hi I am using a AIR-CAP3602I-E-K9with the Software Version: ap3g2-k9w7-xx.153-3.JF10 (ap3g2-k9w7-tar.153-3.JF10.tar) The Web GUI Works and I can do changes: I tried:ap3g2-k9w7-tar.153-3.JF11.tarap3g2-k9w7-tar.153-3.JF12.tar These releases definitely ...
Hi,
sorry still without success
But the rule is a little bit different right?
I created it like this:
nat (inside,dmz) 1 source static obj_locallan obj_locallan destination static NETWORK_OBJ_10.10.10.0_24 NETWORK_OBJ_10.10.10.0_24 no-proxy-arp
...
Hi,
the host route comes automaticaly when connecting via AnyConnect.
Before I connect with anyconnect the routing looks good:
# show route
Codes: L - local, C - connected, S - static, R - RIP, M - mobile, B - BGP
D - EIGRP, EX - EIGRP ex...
Hi,I route the whole traffic through the VPN tunnel.and I can see the Traffic on the ASA:
6 Aug 13 2014 16:12:01 302021 10.10.10.11 11229 192.168.1.10 0 Teardown ICMP connection for faddr 10.10.10.11/11229(LOCAL\Administrato...
thx that sounds great I am using c1841-adventerprisek9-mz.151-4.M8.bin.But I couldn't find any option for that in the CCP. But I think this option isn't available in the CCP yet.Are there any configuration examples?
