Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi All,We have both Active / Standby Cisco FPR-2110 Firewalls which are constantly using high memory. Free memory: 1902561200 bytes (27%)Used memory: 5059307600 bytes (73%)------------- ------------------Total memory: 6961868800 bytes (100%)Note: Fre...
Hi guys ,
I have installed the CSM 4.10 and looks like I'm getting an error : Rollback Configuration Failed.Please check failover configuration. Failed to Rollback due to improper failover configuration.
We're running Cisco ASA 5515X Failover setup...
Seems the --- show interface name detail --- works. Just tried it. Will monitor and see after a few days. I need to use it for Flow-Traffic enablement. Seems the NMS we're using is only tracing the IF-INDEX. Thanks for you share !!!
Hi All, I had a similar problem as well ...But here is what I noticed ... show lacp interface Eth2/14Interface Ethernet2/14 is suspendedChannel group is 35 port channel is Po35PDUs sent: 16729PDUs rcvd: 0 <----- So , because the PDUs rcvd is 0 ......
Hi there, I found similar SWE Flag when I did packet capture during tshooting. Turns out, there is another device after this firewall which is blocking the traffic.So , it seem from the packet capture example above -- only Syn is sent. Syn/Ack is no...
