Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,
I'm looking at setting up a new router for another branch that will be opening up. I cannot seem to get a static route to work. We are setup for VPLS through our ISP so all routes are pointed to 192.168.10.6 which is our hub site. Below is t...
Hello,
I seem to be getting odd MAC addresses showing when I run "sh ip dhcp bind" on any of 3 Cisco routers with DHCP enabled that I have.
(see pic)
Am I missing something here? Is 013c.15c2.2b1f.23 a valid MAC address?
Hello,
I just got done install 3 new routers, 2911, and two 1941's. Two of the three routers I can access ccpexpress through my browser. There is one of the 1941's that I can't, no login, nothing but "Page can't be displayed". I can telnet into all ...
We recently upgraded our bandwidth from 30Mbps to 100Mbps from our ISP. Ever since then we have been having problems with bandwidth to our two branch sites. I had to struggle to get everything connecting at 100 Full Duplex, forcing some to take. We p...
We are looking at replacing the routers at my place of business. It is a small organization with about 200 users. We have 3 branches. The topology is a basic hub and spoke with 2 remote sites that are connected with our main site by SFP fiber capped ...
Hello,
Sorry for the late response. I was having no luck with the test bed router so I decided to take the new production router to the new site and connect and configure it there. After configuring interfaces, passwords, and DHCP pools I added the...
I cannot ping 192.168.10.6. Interestingly enough I had someone from our ISP there with me. He had come out to check the fiber connection to the SAS box. He could see the MAC address of our router from his end. I did have to enable IP Routing to get t...
HELP
So I reset configured a old 1841 router I had and I'm onsite and no connectivity. Here is the config for the 1841. Something missing in the routing are the local connections. Do I need to add other statc routes other than the 0.0.0.0 ? How do ...
