Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I was just preparing to do a fresh installation of the 2.3 release when I noticed the release notes went missing.The version in the release notes overview is also empty.Release Notes for Cisco Business Dashboard, Version 2.3 - Cisco I don't know if i...
Hi, I'm getting stuck with the access points in my CBD setup, perhaps someone can point me in the right direction.The access points remain offline in CBD, and although I have wireless networks configured I only see the CiscoBusiness-Setup SSID. Both...
I have 2 AP's (CBW240AC-E and CBW140AC-E) which are connected to CBD using pnp connect. When claiming the devices it is mandatory to select an image from CBD to use on the device. Unfortunately the devices are stuck on provisioning.The provisioning l...
Is it possible to share a roadmap of CBD development? Just to give us a peek of what features are in development? Though the deployment of my test environment isn't going as smooth as hoped I believe CBD has a huge potential for the SMB market.
Hi all, I've been working on a test setup with Business Dashboard and am running into some problems I can't seem to solve. The setup:Cisco Business Dashboard running in Azure on Ubuntu 16.04Network EquipmentRV340 router RV340-K9-G52x Business 250 Sm...
It's been a while since I have been working with CBD.To my best recollection I think this was resolved, the main issue was an error in the config template I used to provision the AP's. The last time I checked there wasn't any builtin template for the...
So you have CBD running in the local network and you're using the probe in CBD?That's a different setup from what I have (CBD in Azure, probe running on the CBS switches). In my case the CBD certificate get's pushed to the devices by PnP connect and ...
Sorry for the late reply. Are you using PnP connect to redirect your devices to CBD or are you manually connecting the devices to CBD?You shouldn't have to upload private keys to the RV to be able to connect to CBD. The router will try to verify the ...
Hi Dave, Good to know it is being considered, even on a lower priority. I agree most of the work is in configuring switches/AP's. Most of the L3 (and other) config can be don thru the templates using Mustache. Regards,Niels
I've got a test setup sort of working now. Is it not possible to manage L3 networks? This would mean that after creating L2 networks and SSID's you would also have to configure the uplinks to the router/firewall to add the vlans and create the L3 int...
