Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello everyone,I'm currently using a 3702E AP in Autonomous Mode for some performance tests and I would like to monitor the following parameters: SNR, RSL and SIR. However, I was enable to find these parameters among the variables provided by the MIB...
Hello community,Could you tell me what version of IOS do I have to use for an AP 3702i in order to configure it in Autonomous Mode (and not only in Site Survey).The current installed version of the IOS is 15.3(3)JBB. (ap3g2-k9w7-xx.153-3.jbb)On this ...
Hello community,Could anyone tell me whether this router model is using the "transmit diversity " or the "spatial multiplexing" for MIMO?Thank you.Roxana
Hello community, I'm currently working on a C819HG-4G-K9 (version 15.2(4)M4) router and I've encountered some problems when using SNMP for getting the values of some parameters, like the RSSI.For this device, the SNMP Object Navigator tool indicates ...
Hi Daniel,I've launched myself in finding another parameter from the CISCO-WAN-3G-MIB: c3gTxTotalPower (OID 1.3.6.1.4.1.9.9.661.1.2.6.3.1.10). Unfortunately, I am unable to get its value.When trying to smpget the OID, I get:root@ImapDEMO:~/.snmp/mibs...
As I was unable to find an OID corresponding to the SNR parameter, I chose to build a script which launches the "sh cellular 0 radio" command on the router and then identifies the value corresponding to the SNR parameter.
Thank you for your reply. You were right.I've also upgraded the IOS to 15.4(2)T. If I may bother you with another question, I would like to know how can I get/ calculate the SNR value that is shown when executing:Cisco4G#show cellular 0 radioRadio po...
