Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello, I am trying to use ip community-list together with route-map exact match: ip community-list standard Filter1 permit no-advertiseip community-list standard Filter1 permit 65004:66 However i faced this problem: R(config)#route-map Filter-inR(con...
Hello,
Currently have a cisco 7600 router with IOS 12.2(33)SRE12 and would like to rate limit the udp traffic from a host. Currently have this setup:
ip access-list extended LIMIT-UDP-IN remark LIMIT-UDP-IN permit udp host 1.2.3.4 any!ip access-list...
Dear all
According to the documentation, it should be supported,
http://www.cisco.com/c/en/us/products/collateral/interfaces-modules/qa_c67-612908.html
However, i cannot found out any documentation, or any cases on the internet, that can enable th...
HI all,
I Have a 6509 router running in production environment, but I am planning to switch it to a 7604 router.
While I dont have the problem of the config between them, it seems that from a unknown reason, there is some MPLS routers that exists on ...
Hi, We are trying to setup port-channel with redundancy 1:1 with our 6509 router, but we found that we cannot use the command: lacp fast-switchover Router(config-if)#lacp ? max-bundle LACP maximum number of ports to bundle in this port channel Rou...
Hello Richard,
I have also tried on a layer3 port, say i have this config in the other router now
access-list 192 remark **LIMIT-UDP-OUT**access-list 192 permit udp any host 1.2.3.4
class-map match-any LIMIT-Traffic-OUT match access-group 192
...
Hello George,
Thanks for your suggestion, now it shows
Match numbered access-list is not supported for this interface
Not sure why it only have problem of "service-policy output " only? service-policy input can apply successfully without any pr...
Hi Julio,
Thanks, I dont think i have setup MP-BGP . I do have ISIS with BGP on the router.
Here is the result on my 7604 with the suggested commands:
7604#show bgp vpnv4 unicast summary ^% Invalid input detected at '^...
