Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hey Guys, Need assistance in BGP looking glass, i check my transit routes in BGP looking glass and its showing AS twice. BGP routing table entry for 88.196.6.0/19
Versions:
Process bRIB/RIB SendTblVer
Speaker 158007868 158...
Hey Guys,
We have a router with three sub-interfaces Gig0/1.111, Gig0/1.222 and Gig 0/1.333.
I would like to set Gig 0/1.111 and 1.222 to use Gig0/2 ISP and Gig0/1.333 to use Gig 0/3 ISP.
My problem is we cant use VRF and static routing due to li...
Hi All,
I have a 2911/k9 router with Guest network and DMVPN configured, as per documents the speed of the router is 180Mbps but I am getting 100Mbps for Guest and 20Meg for Tunnel users. is this fine ? should I get 100Mbps on both or 100 + 20 will...
Hey Guys, I am trying to telnet my router but its not TELNETTing it; Router 1:IP - 10.1.1.1access-list 30 permit 10.144.0.0 0.0.255.255line vty 0 5 access-class 50 in Layer 3 SwitchVLAN87 - IP 10.1.1.2VLAN88 - IP Address - 10.144.1.10 255.255.255.0...
Is it possible I can load-balance my client ? In our current setup when one AP down rest of the client move to other AP, we need to move them manually or connect/disconnect. I can apply max-association on SSID but is there way I can do it automatical...
Looks like its not enable as the IOS is ipbasek9:
Router 2911, I was under the impression all 2911/K9 have this option enable. I dont see any error on logs but I do see high utilization on process Licensing Auto U.
show license FEaturFeature nameEn...
