Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I didn't find compatable sfp module for WS-3850-12S in "Cisco Optics compatibility matrix" for operate in smf 100mb. Is there any sfp to use in smf 100mb for this switch?
HI, everyone!
I can't instal IOS (cat3k_caa-universalk9.16.03.06.SPA) on WS-3850-12S. An error occur. Before the installation I cleaned up memory. I tried to install cat3k_caa-universalk9.16.08.01a.SPA and cat3k_caa-universalk9.SPA.03.07.05.E.152-3.E...
Virtual interface in WS-C3850-12S is often freezes. And there are no log messages about it. Traffic is always minimum so I don't see any obvious reasons for it. The network which is concerns to this interface is not avaliable at that moment. I do "sh...
Problem with operating Cisco 3850-12S (CAT3K_CAA-UNIV ERSALK9-M), Version 03.03.05SE RELEASE SOFTWARE (fc1)) and 2 types of sfp modules:
1. AT-SPFX/15
2. OptiCin SFP-Plus-LR.LC.10
I entered this commands "service unsupported-transceiver", "no errdisa...
Router#sho interfaces vla 114Vlan114 is up, line protocol is up Hardware is Ethernet SVI, address is 0041.d213.bcec (bia 0041.d213.bcec) Internet address is 10.14.254.254/16 MTU 1500 bytes, BW 1000000 Kbit/sec, DLY 10 usec, reliability 255/255, txloa...
I use one of the latest firmware 3.7.4E(ED)(cat3k_caauniversalk9.SPA.03.07.04.E.152-3.E4.bin). Release Date 25-MAY-2016.
Before it was 3.3.5SE(ED) (cat3k_caa-iosd-universalk9.SPA.150-1.EZ5.bin) and the problem was the same((
