Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have a pair of 6807-XL with Sup-2T & VPLS License. I have configured MPLS VPN without a P router. Both Switches are connected with a L3 Link.Somehow the Web Browsing for one of the VRF doesn't work. I can PING to websites, traceroute works, outlook...
I am trying to figure out the Flexible Net-flow on Cat 4510R+E Switch running IOS-XE code. My Neflow flow software is manageengine 7.X. I am able to see the netflow interfaces but the traffic itself is not displayed. On the Switch I can see the netfl...
I have a PIX525 running 8.0(3) with 256MB RAM & running Restricted License.When i use OUTSIDE Interface NAT the NATing works fine.But when i user any other Global IP for NATing it's not working.Pl. help.
am trying to user PEAP on my AP's in the Enterprise. It works fine when used as WPA2. But when i use dot1x it gives me error 'auidentified server identity'. I am using ACS 3.3 & using self signed cert. on the ACS. The same cert. i have installed in ...
I am trying to user PEAP on my AP's in the Enterprise. It works fine when used as WPA2. But when i use dot1x it gives me error 'auidentified server identity'. I am using ACS 3.3 & using self signed cert. on the ACS. The same cert. i have installed in...
what I want is from certain subnet and from certain hosts I should be able to use a different global ip. This is for all outbound traffic only.I even tried with (debug icmp trace) when I config diff global for nat the request comes on pix, it shows t...
Well it's configured preety simple.There is a NAT statement for my private IP'sNat(inside) 1 10.0.0.0 255.255.255.0& global(outside) 1 interfaceIt works well on this.But for the following config it's not working.Nat(inside) 2 10.0.0.1 255.255.255.255...
I do not have a CA in my Enterprise. I am using the ACS self-signed certificate. Also adding this certificate in the ACS Cert. Storage & also trusting the cert.The same cert. i am installing in the client.Do i have to use a different cert. for the cl...
hello vibhor,i tested enabling icmp trace.on the PIX1 i can see the icmp request coming & icmp reply send to PIX2. but pix2 is not responding.it certainly seems to be a problem of the port. can it happen that a single port of the 4-port card can fail...
Hello,I am not able to ping the inside interface of the standby PIX from my ACTIVE PIX. I can ping the dmz interface of the standby PIX from ACTIVE. I changed the switch port also but shows the same Normal(waiting).when i disconnet the standby PIX in...
