I have the current rules in an attempt to open port 5060 and 10000-20000 for my VoIP provider. We are on a Cisco 1921 router. This ACl is applied to the WAN port on the router facing the ISP. Nmap port scan shows these ports as closed. Can som...
I have a cisco 1921 router performing routing and NAT function. Cisco 3750 is performing layer 3 core switching duties. Users are complaining about large file transfers being stalled (not dropped) down to 0Mbps and then the connection bounces back ...
I am running IOS 15.2(4) on a 1921 RouterWhat is the best way to configure the password for the router? I have already tried once and managed to lock myself out of another switch. I would like to use the most secure method which encrypts the passwo...
I can't figure out what happened but I can not enable privileged mode in my Cisco 3750. I am stuck in Read-Only mode.
At first, I tried:
enable
to enter EXEC mode. My password would not work and it kicked me out after 3 retries.
Did some trou...
It was just a statement not necessarily a comparison. I understand the Cisco documented specifications but those are clearly understated and represent a router under full load with all services turned on. My connection is peaking up to the full 100...
Ya I understand CCNA101. 15Mbps is rated for the router under full load. My CPU is under 7% and Bandwidth isn't even topping 10Mbps. You can see from my config that the only things I am running on the 1921 is NAT and ACL's.
Yes the internet connection is routed through an IP interface on port G0/1 (removed the ip for security purposes). The internet connection is 100/20. I find it hard to believe that a $500 router cannot push more than 15M upload. I might believe th...
Here are interface statistics from my Router and Switch. Noticed a lot of dropped packets in the output queue. 1921 Router: GigabitEthernet0/1 is up, line protocol is up Hardware is CN Gigabit Ethernet, address is 18e7.287c.c141 (bia 18e7.287c.c14...