Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi All We have 2 standalone Cisco 9148 switches.I plan to add new zones to an already activated zoneset in anticipation of new hosts. I am planning not to activate the zoneset after adding the new zones until the new hosts are installed which would l...
Hi AllI would like to create an EEM script on Switch A which ssh's onto Switch B to run a second EEM script.After looking on the Cisco site and forums, I believe the following would allow me to do this:Switch Aevent manager applet Script1action 1.0 c...
Hi AllI hope you can help. We have an AS with 3 routers with 2 or 3 BGP peers on each router.I'm planning to change the Local Preference on one of the BGP peers so that all of the possible traffic is sent via that peer (it is partial transit so not a...
HiI'm currently setting up Nagios/Icinga to monitor our Cisco Switches.I can get a list of Interfaces using the following snmp mib:snmpwalk -v 2c -c <community string> <ip address> 1.3.6.1.2.1.2.2.1.2I can then get a list of the InOctets and OutOctet...
HiThanks. I activated the zoneset and it all worked as expected. Your suggestion would be a better and safer method for doing changes in the future as it offers a clear rollback method. I did clone the zoneset prior to making the changes - but your s...
Hi Walter I have activated it now and it works well. The reason that I postponed the activation is that I created fcalias's without any member. Therefore I was concerned that this might cause an error. The reason that I did this is the pwwn is not k...
Hi Marius#show ip bgp justs shows the entire bgp table entry by entry. I was wanting to summarise the routing table (show ip route) to see how many entries for each next hop.I could then see how the numbers change once the "local preference" is chang...
switch1#show interface vlan6 countersCounters information is not available for Vlan6switch1#show interface vlan6 counters snmp ^% Invalid input detected at '^' marker. John
Hi AfrozFor example vlan 6 is configured on the switch. It is configured on various access ports, on various trunk ports and has its own interface and ip addressThe following snmpwalk shows me the interface index & description for vlan 6.#snmpwalk -v...
