Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
There is a issue with Bandwidth on Interface as it is not properly Reflecting on Tool Even though it has been configured properly on Tools as well on router interface.
Policy-map
policy-map RATE-LIMIT-IN
class OCS-RATE-LIMIT-IN
police 512000 6400...
Hello, Is it necessary to purchase fireSIGHT management and VMware licences for firePOWER services? Is it possible to manage all features of firePOWER with ASDM? What is the best recommendation? Thanks,
Hello all,I had an issue during configuring site to site VPN in RV042 with Fortinet router. Although, it seems everything fine and also performed several cross checks but we were unable to diagnose the actual problem. We got following log message fro...
Hello, I'm getting high latency in my WLAN after deploying 2504 controller with 2504 HA:Since, primary secondary fail-over is working I guess the configuration should be okay.This is the case:While connecting only Primary controller there is no laten...
Hi, I've downloaded ap licence for cisCo wlc 2504 with wrong UDI product Id. Now I am unable to install licence because of incorrect UDI.How would I download again with the correct UDI since, licence order has been already fulfilled.Your suggestions ...
Hi,
You mean the traffic utilization shown in netflow graph was before dropping by rate limit policy? But I would like to let you know that it was working fine for a several years with existing configuration.
If so, how can I fix this issue without ...
Hi,
Here is the interface configuration:
interface Serial0/1/0
bandwidth 2048
no ip address
no ip redirects
no ip proxy-arp
encapsulation frame-relay IETF
logging event subif-link-status
logging event dlci-status-change
load-interval 30
fr...
Fail-over between primary and secondary worked but there is a high latency form end users.Ping result from end users to default-gateway is above 1000ms while connecting both WLC, but it's normal (1-4ms) either unplugging HA or Primary controller from...
Thank you for the reply!I have simple network setup, no radius, tacacs+ server and all devices doesn't support 801.1X.Currently preshared key is in used as a security option.There is a Active Directory in my network but no security parameter was defi...
