Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
We are having issues with our Aironet access point. It is not connected to a controller.
It keeps disabling the 2.4ghz interface.
Here is our config:
#sh run
Building configuration...
Current configuration : 5892 bytes
!
! No configuration change ...
I've installed Cacti on ubuntu 14.04 and am trying to add a Cisco sg300 to it.so the switch is configured like this:snmp-server location My Officesnmp-server contact sysadmin@blahsnmp-server community MyC0mmun1ty ro 192.168.10.25 view Defaultthen in ...
I've been asked to add a user to our asa 5520 firewall with privilege level 5.how should I do this? I did:username test password blah privilege 5but when they ssh to it they just get to the > prompt. How can they enable without giving them the enable...
We have a cisco 515 configured for L2TP over ipsec vpn.Once connected we cannot browse the internet, we can ping internal network fine. If send all traffic through gateway is ticked on the client we still have the same issue.We have a flat network so...
Yes that works!I wonder if it's because the cacti server is a virtual machine on hyper-v?That is definitely it's ip address as I ssh to it and ran the command from there. It only has one nic active and if config show's the right ip.Thanks for your he...
Thanks that was an error on my part when I pasted, I deleted the last octet by accident and manually wrote it in.
The ip in sh snmp is in fact 192.168.10.25
If I try snmpwalk with an oid shown on the screen shot
~# snmpwalk -v2c -c MyC0mmun1ty 192...
no it still shows snmp error. I tried removing and adding the device.
#sh snmp
SNMP is enabled.
Community-String Community-Access View name IP address Mask
-------------------- ------------------ -------------- -------...
