Hi,Please check the attached diagram. What I am trying to do is, if I try to connect a host to router ethernet IP address can router nat that entry and forward it to dialer interface. And also if first natted host is not available, is there any confi...

Hi,We have 20 routers and switches of different models and we want to log or audit all the changes made to these devices.Can someone please tell me whats the best way to log everything from these devices including telent, config chagnes ....etc. Tha...

Hi,we are using cisco switches and I have configured two ports on each switch as trunk ports. what I want is for vlan 29 all the traffic to go via port2 on switch1 and it only uses port1 on switch1 when port2 is down. can someone tell me how to do th...

Hi,we are using cisco switches and I have configured two ports on each switch as trunk ports. what I want is for vlan 29 all the traffic to go via port2 on switch1 and it only uses port1 on switch1 when port2 is down. can someone tell me how to do th...

Hi,I am configuring natting and having bit of problem. Our setup is like: Ethernet serial EthernetHost1<------->R3<-------->R2<---------->Host2IP addressesHost1 - 192.168.1.5Host2 - 10.1.0.1The way its configured is that I Host2 will try to ...